02.21.08
Posted in Spa, chemicals, safety, spa safety at 8:28 am by pcpools
Spa Safety Tips
- Read and follow all label directions before using chemicals or adding them to your spa water.
- Always add chemicals to spa water, never water to chemicals.
- Add each chemical separately.
- Wait 15 minutes before adding any additional chemicals.
- Do not combine different chemicals before adding them to the spa water.
- Accurately measure amounts when adding chemicals. NEVER OVERDOSE! Adding more than the
recommended amount will most often cause problems, not solve them.
- Whenever you add chemicals to your spa, let the water circulate for at least 30 minutes
before use. This lets the chemicals thorouly mix with the water.
- Keep all chemicals away from your face and never inhale fumes.
- Never smoke around chemicals.
- In an emergency involving chemicals, follow label directions. Always keep emergency phone
numbers handy.
- Always re-close chemicals tightly after use and store in a cool dry place.
- Store chemicals according to the manufacturer’s label and keep out of the reach
of children.
- All chemicals, if not handled properly, may be dangerous.
- Maintain proper sanitation levels.
- Never heat your spa above 104 decrees Fahrenheit.
- Limit your spa session to 15 minutes.
- All users should shower without soap before entering the hot tub to remove excess
deodorant, lotion and body oils.
- Adult supervision must be present when children are using the spa.
- Do not consume alcohol while using the spa.
- If you are pregnant, have high blood pressure or other cardiovascular condition, consult a physician before using a spa.
Permalink
02.13.08
Posted in Above Ground Pool, Automatic pool cleaner, Diving Boards, Heat pump, Heaters, In ground pool, Pool, Pool Deck, Pool Ladders, chemicals, liners, pool filter, pool pump at 2:22 pm by pcpools

Remove all leaves, debris & excess water from pool cover. Use Submersible Pump to clear water away. Then remove the pool cover.
Check the condition of your Pool Liner. Need to replace your pool liner?
Remove all winterizing plugs from the pool suction lines and return lines.
Assemble all pool pump and filter pipes to respective fittings. Check the condition of the sand, cartridge or DE elements. Clean or replace if necessary. Need to replace your Pump & Filter System?
Be sure the pool filter top is secure, the tank drain is closed and the pool filter valve is in the “Filter” position.
Hook up pool pump, filter and any other additional equipment you might have (Pool Heaters, etc.).
Re-attach any deck equipment you have such as Pool Ladders, Diving Boards, etc. Install all Pool Deck equipment including skimmer baskets and return directionals.
Bring the pool water level up to normal & Start the pump.
Using Blue Wave Chemical Start-up Kit, follow our FREE Pool Care Guide directions to get your water in swimming condition! Balance the water chemistry and check the levels frequently during the first few days (until they stabilize).
Run the pool pump & filter system 24 hours until your pool water has cleared completely.
Remove any debris from pool using an Automatic Pool Cleaner or Pool Cleaning Equipment.
Clean Liner with Tile & Vinyl Cleaner & clean Filter with Filter Clean.
For more detailed Pool Opening Instruction, in Printer Friendly Format, Click Here.
Permalink
02.05.08
Posted in Above Ground Pool, Automatic pool cleaner, In ground pool, Pool, pool filter, pool pump at 2:38 pm by pcpools
Automatic Cleaners
A suction cleaner works off the vacuum of
the pool’s filtration system to suck debris from the pool bottom and does
not require a separate booster pool pump. This is the least expensive
automatic pool cleaner to purchase and is the easiest to install. It cleans
whenever the pool filter is running. A suction pool cleaner is highly
recommended only if the pool if relatively free from heavy leaves, pine
needles and twigs.
Above Ground suction type pool cleaners offered by pcPOOLS are
Trident
Dirt Devil®
Ranger™
Zoom™
Barracuda® Zippy™
‘Lil Shark™
Inground suction type pool cleaners offered by pcPOOLS are
Dirt Devil®,
Barracuda® Pacer™,
Barracuda® G3™,
Barracuda® G4™.
Robot Cleaners do not have to be hooked up to the filtration system.
They are fully automatic, computerized, has its own drive motor and filtration
system and filters your pool water at the same time. Since it has its own motor,
it works independently of your pool filter system, and purifies your pool
water as it helps distribute pool chemicals.
Above ground
Pool Rover,
Pool Rover Jr.™,
Dolphin Robo-Kleen.
Inground
Aquabot™,
Aquabot™ Turbo,
Aquabot™ Turbo Remote,
Aquabot™ Turbo T,
Aquabot™ Turbo T2,
Aquabot™ Turbo T4 - RC,
Dolphin™ 2001 Diagnostic,
Dolphin 2002 Dynamic w/Remote & Caddy,
Dolphin HD™ Commercial Auto Cleaner,
Dolphin™ 3001 Commercial Auto Pool Cleaner w/ Caddy,
Dolphin™ 3002 Commercial Auto Pool Cleaner w/ Caddy & Remote,
Dolphin 2×2 Commercial Auto Pool Cleaner,
Orion™ Automatic Pool Cleaner.
Other types include pressure Mars HP. This advanced cleaner uses jet propulsion technology to drive out of deep-end hoppers and move around obstacles.
Permalink